Washer not draining or spinning. Sometimes, the problem isn’t really in the washer. You need to check additional areas that might have issues. Open up your machine’s control panel Check for a clogged plastic tube attached to the water level valve If there is one, use vinegar to unclog it.
Takes some time to clean out If you’ve already done all of that, then the problem with your washing machine could be a faulty water level valve replacement which would cost more than fixing it other ways many times over so make sure.
That every area excluding the actual washer itself has been carefully checked as a potential source of fault first before deciding on blaming it on something else entirely just because it makes things simpler if nothing is working properly.
Washer not draining or spinning
If your washing machine won’t drain then there are a few things that could possibly be the reason why. Your washer may have water leaking back up into it.
the tub and for this, you should check for any clogged hose or a malfunctioning pump which can be detected by checking to see if your machine is draining properly in all settings, even the spin cycle.
Open Up the Washer
Before you even begin to start washing, unplug and disconnect the machine. Start by gently pulling the lower portion of the front panel outward before detaching the top end by unhooking it.
Look for the Clog and Pull It Out
The pump is actually contained within the housing of the tub. You’ll probably see the obstruction with your own eyes due to its translucent qualities. kenmore series 500 washer stuck on sensing Loosen the clamp holding the hose to the bottom of your tub and remove it as well.
Remove both ends of the belt from their respective points before unhooking it completely and pulling it free. Unwind any obstructions as you pull them out by turning both ends of your belt in opposite directions once removed completely.
Washing machine’s access panel
Your machine will contain a pump. It’s most commonly located on the back of your washer, but sometimes it can be possible to access from the front if there are 2 screws on one side. Don’t let this fool you into needing to use these screws though – typically, access is at the back, as we see with top loading machines.
Your owner’s manual would have pointed you toward where your pump is too, and should also hold information about where all parts of your machine list inside through each sub-section specific to that individual part in case it isn’t all in 1 spot.
Remove the lower screws
Use your screwdriver to carefully unscrew each of the screws. Place the screws in a safe spot so you can replace them later. As you remove the screws, hold the panel in place so it doesn’t fall off of your hand until you are ready to deal with its contents. These screws are typically at the corners of your pump and should be easily accessible.
If they aren’t, there may also be a small black flap or cover that can simply be pulled back to reach your machine’s pump. That way you won’t have to dismantle any more than is absolutely necessary which will make reassembly easier later on!
Fix washing machine drain pump
Washing machines might experience mechanical issues sometimes. Once in a while, a piece of laundry can block the pump, making it hard to move and causing other parts of the machine to start to act up.
There are many different causes of mechanical failure – but they’re all related, and what you need to do is ask your machine’s manufacturer as soon as you notice something is wrong with your washer.
Conclusion
There are a few things that could be the reason why your washing machine is not draining. When undertaking a drain cleaning project, first check if the washer is draining into the sewage system at mykitchenpoint.
You can check this by opening the washing machine lid and seeing if the water is flowing into the pipe.
